-
Free Shipping
Orders $75 & Up
-
30-day Money Back
Guarantee*
-
100% Secure Online Shopping
SSL - Verified Merchant
eWheels EW-27 and EW-32 Battery Replacement Kit: Four 12V 20Ah (20-hr rate) AGM Batteries
Does This Kit Fit Your EW-27 or EW-32?
Confirm the kit against your scooter before ordering.
- Model name - The scooter should read EW-27 or EW-32.
- Battery count - The compartment should hold four batteries. A different count means a different kit, so call first.
- Dimensions - The compartment does not flex, and the originals should measure the same as these: 7.13 x 3.03 x 6.57 inches, with threaded insert terminals.
If you are comparing eWheels battery replacement options, the eWheels scooter batteries page shows every kit, and the mobility scooter battery finder matches a scooter to its kit. The EW-29 and EW-37 have their own listings.
What Is in the Kit
- 20.0Ah over 20 hours - That is the rating on Origin's sheet, measured at 77 F (25 C).
- 14.3 lbs per battery - Roughly 57 lbs for the four, so move them one by one.
- Temperature limits - Discharge from -4 to 140 F; charging from 14 to 140 F.
Specifications
| Origin OR-12220HR Specifications (EW-27 / EW-32 Kit) | |
|---|---|
| Part Number | Kit EEW27 (EW 27, EW27, EW 32, EW32); batteries OR-12220HR |
| Kit Contents | 4 batteries |
| Battery Type | Sealed lead acid, AGM |
| Nominal Voltage | 12V per battery |
| Nominal Capacity | 20.0Ah at the 20-hour rate (1.00A to 10.5V, 77 F / 25 C) |
| Terminal Type | Threaded insert |
| Length | 7.13 inches (181 mm) |
| Width | 3.03 inches (77 mm) |
| Height | 6.57 inches (167 mm) |
| Weight | 14.3 lbs (6.50 kg) per battery |
| Operating Temperature | Discharge -4 to 140 F (-20 to 60 C); charge 14 to 140 F (-10 to 60 C) |
| Warranty | 1-year free replacement (High-Tech Battery Solutions) |
How to Install the Batteries
- Switch off - Turn the scooter off and disconnect it from the charger.
- Open the compartment - The batteries usually sit below the seat; remove the seat assembly if needed.
- Record the connections - Photograph how the cables are attached before removing anything.
- Exchange the batteries - Unlatch the cover, take the old batteries out and place the new ones in the same layout.
- Connect and check - Attach each cable as it was, secure the compartment and test the scooter.
Warranty
Frequently Asked Questions
What is the right replacement battery for my mobility scooter?
Start with the scooter's model name and compare it with the kit listing. Then read the label on your current batteries, where the front face shows voltage, amp rating and part number (the owner's manual lists them too). If the label reads anything other than 12V, call 1-877-775-4381 before you order.
Do I need AGM or lithium batteries?
Look at the label on your current batteries. Two or more separate blocks marked sealed lead acid are a lead acid set, and sealed lead acid covers both AGM and gel types. This kit is AGM, so call 1-877-775-4381 if your label says gel. A single block marked Li or LiFePO4 is lithium, and this kit does not replace it.
Why does my scooter run short when the charger says it is full?
Batteries lose capacity gradually, and a full charge on a worn set carries you less far. Mobility scooter batteries typically last 18-24 months.
Do my old batteries have to be the same brand?
Brand is not the test. Voltage, physical size and terminal type are.
Call with your scooter's model name and a look at one old battery label. A battery specialist will confirm the kit before you place the order.
Call 1-877-775-4381 · battery specialists, not a call center